Laserfiche WebLink
� t - <br /> Installation and Maintenance Instructions for the following <br /> products: LT-18 LT-1/16", LT-1/32", LT-1/64 <br /> Installation <br /> Step 1 Dry fit the filter case onto the outlet pipe going to the drain field.Ensure it is centered directly under the <br /> access opening.(if outlet pipe is already in a fixed position,additional pipe may need to be added) <br /> Step 2 If utilizing the additional single side support and the two bottom supports: While the case <br /> is still dry fit to the outlet pipe,measure and cut 1"schedule 40 pvc pipe to the length needed to extend from the <br /> hubs that are pre-molded into the case to the side wall and the inside floor of tank. solvent weld pipe into the <br /> hubs that are pre-molded onto the case. <br /> Step 3 Solvent weld the case to the outlet pipe. Insert the filter cartridge into the case pressing down on the <br /> cartridge until it locks into place at the bottom of case. <br /> Maintenance <br /> 1) Remove the access lid of the tank. Note:To ensure undesirable solids do not exit the tank and into the <br /> drain field,the tank should be pumped out until the level of effluent is below the outlet level of the tank. <br /> 2) To remove the filter cartridge from the filter case,pull up firmly on the handle of the cartridge dislodging <br /> it from the case. <br /> 3) Using an ordinary garden hose,rinse the filter cartridge ensuring all visible septage material is removed. <br /> 4) Place the filter cartridge back into the filter case pressing down on the cartridge until it locks into place. <br /> S) Place the access lid back onto the tank ensuring it is secure. <br /> 6) It is recommended that these steps be performed each time the tank is serviced. <br /> Contact information: <br /> Lifetime Filter LLC V ! AAA <br /> PO Box 160 <br /> Hillview KY 40129 <br /> Phone-502-724-2231 <br /> Email-mike@lifetimefilterlic.com <br />