Laserfiche WebLink
PLOT PLAN REQUIREMENT <br /> A plot plan drawing is required to be submitted along with this application. The plot plan drawing shall either be drawn to <br /> scale,in feet,or be FULLY dimensioned in feet. Please note the scale on the drawing.if one is used.The plot plan drawing shall <br /> be on letter or legal size paper with North being at the top of the page. (Make cure all relevant items below are shown—check <br /> each relevant box): <br /> O Property lines,road right-of-ways,and road centerlines including distances to property lines,road right-of-ways and road <br /> centerlines for all existing and proposed structures on the parcel <br /> D Ordinary High Water Mark(OHWM)when existing,and distanccs to it from all existing and proposed structures <br /> ❑ Provide Total impervious Surface(IS)Percentages including new existing and proposed development.This standard is only <br /> applicable if the proposed project is within 300'of the OIIWM of any body of water. You only need to count the impervious <br /> surfaces that arc partially or entirely within 300' of the OHWM of a body of water. To calculate,divide the total existing and <br /> proposed impervious surfaces in square feet by the total square footage of the parcel above the OHWM.Then multiply that number <br /> by 100 to get a percentage.Example: 2.500 square feet of IS within 300'of OHWM _43,560 square foot parcel x 100= 5.74% <br /> impervious surfaces(I acre=43.560 square feet). Impervious surfaces include but are not limited to:building roofs,sidewalks, <br /> decks,patios,cement/asphalt/gravel driveways,etc. If the proposed project exceeds 15°43 impervious surface,mitigation is required. <br /> If the impervious surface exceeds 30°%o,you will need to apply for a variance. NOTE: if you are only replacing existing legally <br /> built structures within the same footprint,no impervious surface calculations are needed.Land Services reserves the right to <br /> require a survey when there arc disputes over this calculation. <br /> u Floodplain and wetland areas/boundaries and distances to them from ail existing and proposed structures <br /> ❑ Existing and proposed structures on the parcel including all decks/porches/walkways/etc:must show dimensions for ALL items <br /> ❑ Existing and proposed sanitary system and well locations including distances to existing and proposed structures <br /> O Heights for all existing and proposed structures NOTE: Height is measured from lowest adjacent grade to the highest roof peak <br /> ❑ (Commercial/Industrial Only)Existing and proposed parking:must show dimensions and proposed number of stalls <br /> O Existing and proposed driveways:must show dimensions and width NOTE:Driveways must have a cleared width of 20 ft and a <br /> cleared height of 13 ft.and sufficient turn-around space for rescue services to utilize <br /> U North arrow <br /> O Vegetation proposed to be removed or disturbed <br /> O Location and extent of proposed filling/grading <br /> U Location and type of erosion control measures <br /> ❑ Construction plans shall be submitted with this application for all Commercial/Industrial related construction. <br /> Construction plans shall show interior layout,exterior profiles and exterior heights. <br /> O Proposed building/structure locations must be staked prior to submitting this application to the Land Services Department. <br /> County staff will do an onsite visit to verify site conditions. If all proposed structures(including decks,patios,retaining <br /> walls,etc)are not staked upon County staff visit,the permit may not be approved and may be returned to the applicant. <br /> O If all existing structures on the parcel are not shown and dimensioned on the plot plan drawing,the permit may not be <br /> issued and may be returned to the applicant. <br /> Page 2 of 5 <br /> Burnett County, WI Land Use Application—Rev 12/2021 <br />