Laserfiche WebLink
Safety and Buildings <br /> 10541 N RANCH ROAD <br /> HAYWARD WI 54843 <br /> -8777 <br /> www.commercest0ate?w� <br /> Ivisconsin www.commerce.state.wi.us/SB <br /> Department of Commerce Tommy G.Thompson,Governor <br /> Brenda J.Blanchard,Secretary <br /> November 28,2000 <br /> CUST ID No.227691 ATTN: POWTS INSPECTOR <br /> WADE A RUFSHOLM ZONING OFFICE <br /> 24702 LIND RD BURNETT COUNTY SPIA <br /> PO BOX 514 7410 CTH K#102 <br /> SIREN WI 54872 SIREN WI 54872 <br /> RE: CONDITIONAL APPROVAL P.Q.V <br /> PLAN APPROVAL EXPIRES: 11/28/2002 Identification Numbers Condit <br /> Transaction ID No. 447822 <br /> Site ID No.201847 <br /> Please refer to both identification numbers, "s^ <br /> RTMENI <br /> SITE:Site ID:201847, KEN JOHNSON above, in all correspondence with the a enc 0 o1 SAF' <br /> BURNETT County,Town of SWISS;HWY 77 E <br /> S23,T41N,R16W Lot: 3, <br /> FOR: NEW MOUND,300 GPD SEE CORK <br /> Object Type:POWT System Regulated Object ID No.: 770502 <br /> The submittal described above has been reviewed for conformance with applicable Wisconsin Administrative Codes <br /> and Wisconsin Statutes. The submittal has been CONDITIONALLY APPROVED. The owner,as defined in <br /> chapter 101.01(10),Wisconsin Statutes, is responsible for compliance with all code requirements. <br /> The following conditions shall be met during construction or installation and prior to occupancy or use: <br /> 1. This plan action is subject to designer comments on the plan. <br /> 2. The maintenance plan for this system must be given to the owner of the POWTS. <br /> 3. The orientation of the mound system must be such that the longest dimension is oriented along the <br /> surface contour per COMM 83.44(6)(a)2. <br /> 4. Limit activities in the area 15' beyond the down slope edge of the mound per Mound Component Manual. <br /> 5. Surface water drainage shall be diverted away from the system area. <br /> 6. Maintain well and waterline set backs per COMM 83.43(8)(1). <br /> 7. The designer proposes to install an outlet filter to achieve the requirement of wastewater particle size. <br /> Maintenance information must be given to the owner of the tank explaining that periodic cleaning of the <br /> septic tank outlet filter will be required. The outlet filter shall be installed per product approval <br /> stipulations. <br /> 8. Turn up ells with valves and valve boxes or other means of flushing the lines shall be provided. <br /> 9. Holes must be drilled with sharp bit and all burrs and foreign matter removed before installation. <br /> 10. The observation pipes shall be located at opposite ends of the distribution cell at a distance of <br /> approximately equal to 1/6 the distribution cell length. <br /> A copy of the approved plans,specifications and this letter shall be on-site during construction and open to <br /> inspection by authorized representatives of the Department,which may include local inspectors. All permits <br /> required by the state or the local municipality shall be obtained prior to commencement of <br /> construction/installation/operation. <br />