Laserfiche WebLink
OEq Wisconsin Department of Safety and Professional Services q��' ARTA,�NT c) Phone:608-266-2112 <br /> Division of Industry Services moo` Web:http://dsps.wi.gov <br /> 4822 Madison Yards Way t Email:dsps@wisconsin.gov <br /> PO Box 7302 3 e <br /> Madison,WI 53707 �i Tony Evers,Governor <br /> � Dan Hereth,Secretary <br /> FsstoNAti <br /> September 14,2022 <br /> CUST ID NO.:231251 Identification Numbers <br /> RICK BROWN Plan Review No.:PWTS-092202203-C <br /> PO BOX 637 Application No.:DIS-072234695 <br /> SPOONER,WI 54801 Site ID No.:SIT-106981 <br /> Please refer to all identification numbers in each <br /> correspondence with the Department. <br /> CONDITIONAL APPROVAL <br /> PLAN APPROVAL EXPIRES:09/14/2024 Conditionally <br /> APPROVED <br /> MUNICIPALITY: <br /> DEPT.OF SAFETY AND PROFESSIONAL <br /> TOWN OF RUSK SERVICES <br /> BURNETT COUNTY DIVISION OF INDUSTRY SERVICES <br /> SITE: <br /> PLESUMS <br /> 1732 SLEEPY HOLLOW RD. SEE CORRESPONDENCE <br /> SPOONER,WI 54801 <br /> FOR: <br /> Design Wastewater Flow Value:450 Mound Component Manual-Version 2.1 (May 2022-2027) <br /> Bedrooms:3 Pressure Distribution Component Manual-Version 2.1(May 2022-2027) <br /> Limiting Factor(s):30" <br /> Maintenance Required:Effluent Filter <br /> SITE REQUIREMENTS <br /> • A full size copy of the approved plans,specifications,and this letter shall be on-site during construction and open to inspection <br /> by authorized representatives of the Department,which may include local inspectors. A Department electronic stamp and <br /> signature shall be on the plans which are used at the job site for construction. <br /> The following conditions shall be met during construction or installation and prior to occupancy or use: <br /> • Preserve dispersal area prior and during construction to avoid disturbance,compaction and use of the site. <br /> • Any tall grasses,leaves and shrubs shall be cut short and removed prior to tilling the surface for installation to prevent matting <br /> under the dispersal area. All loose organic material to be removed from POWTS Dispersal Area. <br /> • Prior to construction of the dispersal area,check the moisture content of the soil to a depth of 8 inches.Smearing and <br /> compacting of wet soil will result in reducing the infiltration capacity of the soil.Proper soil moisture content can be determined <br /> by rolling a soil sample between the hands.If it rolls into a 1/4-inch wire,the site is too wet to prepare.If it crumbles,site <br /> preparation can proceed.If the site is too wet to prepare.do not proceed until it dries. <br /> • Abandon Existing System per SPS 383.33 <br /> • Pump Floats to be set and verified per approved plan. Any changes may result in pump resizing to meet TDH and GPM <br /> Specifications. <br /> • Divert surface water from POWTS Area. <br /> • All piping shall conform to SPS Table 384.30-3 and SPS Table 384.30-5 <br /> • Insulate building sewer beyond 30 feet per SPS 382.30(11)(c) <br /> • Tank Installation to follow all manufacture's recommendations. <br /> • Verify property line(s)prior to installation. <br />