Laserfiche WebLink
• Divert surface water from all POWTS Areas. <br /> • Prior to construction of the dispersal area,check the moisture content of the soil to a depth of 8 inches. <br /> Smearing and compacting of wet soil will result in reducing the infiltration capacity of the soil.Proper soil <br /> moisture content can be determined by rolling a soil sample between the hands.If it rolls into a 1/4-inch wire, <br /> the site is too wet to prepare.If it crumbles,site preparation can proceed.If the site is too wet to prepare,do not <br /> proceed until it dries. <br /> • All piping shall conform to SPS Table 384.30-3 and SPS Table 384.30-5 <br /> • Insulate building sewer beyond 30 feet per SPS 382.30(11)(c) <br /> • Well setbacks to meet chs.NR 811 &812 <br /> • Tank Installation to follow all manufacture's recommendations. <br /> • Verify property line(s)prior to installation. <br /> • Pump Floats to be set and verified per approved plan. Any changes may result in pump resizing to meet <br /> TDH and GPM Specifications. <br /> • Areas that are occupied with rock fragments,tree roots,stumps and boulders reduce the amount of soil <br /> available for proper treatment. If no other site is available,trees in the basal area of the mound must be cut off <br /> at ground level. A larger fill area is necessary when any of the above conditions are encountered,to provide <br /> sufficient infiltrative area. <br /> Owner Responsibilities <br /> • The current owner,and each subsequent owner,shall receive a copy of this letter including instructions relating <br /> to proper use and maintenance of the system. Owners shall receive a copy of the appropriate operation and <br /> maintenance manual and/or owner's manual for the POWTS described in this approval SPS 383.54(1). <br /> • In the event this soil absorption system or any of its component parts malfunctions so as to create a health <br /> hazard,the property owner must follow the contingency plan as described in the approved plans. <br /> A copy of the approved plans,specifications and this letter shall be on-site during construction and open to <br /> inspection by authorized representatives of the Department,which may include local inspectors. All permits <br /> required by the state or the local municipality shall be obtained prior to commencement of <br /> construction/installation/operation. <br /> In granting this approval the Division of Industry Services reserves the right to require changes or additions should <br /> conditions arise making them necessary for code compliance.As per state stats 101.12(2),nothing in this review <br /> shall relieve the designer of the responsibility for designing a safe building,structure,or component. <br /> Inquiries concerning this correspondence may be made to me at the telephone number listed below,or at the address <br /> on this letterhead. <br /> The above left addressee shall provide a copy of this letter and the POWTS management plan to the owner and any <br /> others who are responsible for the installation,operation or maintenance of the POWTS. <br /> Thanks,(Tin/ <br /> POWTS Plan Reviewer—Wastewater Specialist <br /> Department of Safety&Professional Services I Division of Industry Services <br /> email: tim.vanderleest@wisconsin.gov <br /> Cell: 608-516-6134 <br />