Laserfiche WebLink
ovs aR rvr�4.�. <br /> Wisconsin Department of Safety and Professional Services Phone:608-266-2112 <br /> Division of Industry Services Web:httn:/'dsps.wi.gov <br /> 4822 Madison Yards Way -3 r r <br /> j Email:dsps(d,,wisconsiu.gov <br /> PO Box 7302 ,. <br /> Madison,WI 53707 'i, / Tony Evers,Governor <br /> t3sxixrt Dan Hereth,Secretary <br /> January 19, 2023 <br /> CONDITIONAL APPROVAL Conditionally <br /> APPROVED <br /> PLAN APPROVAL EXPIRES: 2025-1-19 DEPT.OF SAFETY AND PROFESSIONAL <br /> SERVICES <br /> Plan Review: PWTS-012300088-C DIVISION OF INDUSTRY SERVICES <br /> Mary Huppert Aida, AV <br /> 25720 Firefly Lane <br /> Webster,WI SEE CORRESPONDENCE <br /> SITE: <br /> McFadden <br /> 28132 S Johnson Lake Road <br /> Burnett County <br /> Town of Oakland <br /> 523 T40 R16W <br /> FOR: <br /> Description: 3 bedrooms-450 GPD—20"to GeoMat Mound Manual—(May 2022-2027) <br /> limiting factor—Effluent Filter- Pressure Distribution Component Manual—Ver. <br /> Maintenance required 2.1(May 2022-2027) <br /> The submittal described above has been reviewed for conformance with applicable Wisconsin Administrative Codes <br /> and Wisconsin Statutes.The submittal has been CONDITIONALLY APPROVED.This system is to be constructed and <br /> located in accordance with the enclosed approved plans and with any component manual(s) referenced above.The <br /> owner,as defined in chapter 101.01(10),Wisconsin Statutes, is responsible for compliance with all code requirements. <br /> No person may engage in or work at plumbing in the state unless licensed to do so by the Department per s.145.06, <br /> stats. <br /> The following conditions shall be met during construction or installation and prior to occupancy or use: <br /> Reminders <br /> • If using the existing septic tank,it must be inspected for watertightness and structural soundness,size and <br /> baffles,and must be brought into conformance with the requirements of ch.SPS 383,Wis.Adm. Code. <br /> • The mound site shall be properly prepared prior to plowing.Any grasses longer than 6"shall be cut short and <br /> removed.To avoid matting,any leaves or loose organic matter shall be raked up and removed.Cut trees and <br /> shrubs flush to the ground and leave stumps.Avoid operating equipment on the mound site. If necessary,use <br /> only tracked equipment,during dry conditions,with minimal passes,to avoid compaction. <br /> • 12"of sand shall be installed between the contour and the bottom of the GeoMat product. <br /> • Orifice Shields are required. <br />