Laserfiche WebLink
a ` <br /> PLOT PLAN REQUIREMENT <br /> A plot plan drawing is required to be submitted along with this application. The plot plan drawing shall either be drawn to <br /> scale,in feet,or be FULLY dimensioned in feet. Please note the scale on the drawing, if one is used. The plot plan drawing shall <br /> be on letter or legal size paper with North being at the top of the page. (Make sure all relevant items below are shown—cluck <br /> each relevant box): <br /> +a Property lines,road right-of-ways,and road centerlines including distances to property lines, road right-of-ways and road <br /> centerlines for all existing and proposed structures on the parcel <br /> U Ordinary High Water Mark(OHWM)when existing,and distances to it from all existing and proposed structures <br /> +.1 Provide Total Impervious Surface(IS)Percentages including new existing and proposed development. This standard is only <br /> applicable if the proposed project is within 300'of the OHWM of any body of water. You only need to count the impert ions <br /> surfaces that are partially or entirely within 300' of the OHWM of a body of water. To calculate,divide the total existing and <br /> proposed impervious surfaces in square feet by the total square footage of the parcel above the OHWM. Then multiply that number <br /> by 100 to get a percentage. Example:2,500 square feet of IS caithin 300' of OHWM=- 43,560 square foot parcel 100 5.74% <br /> impervious surfaces(1 acre -3.560 square feet). Impervious surfaces include but are not limited to: building roofs, sidewalks. <br /> decks, patios,cementiasphalt gravel driveways, etc. If the proposed project exceeds 15%impervious surface, mitigation is re guir.J <br /> If the impervious surface exceeds 30%,you will need to apply for a variance. NOTE: If you are only replacing existing legally <br /> built structures within the same footprint.no impervious surface calculations are needed. Land Services reserves the right to <br /> require a survey when there are disputes over this calculation. <br /> J l'loodplain and wetland areaslboundaries and distances to them from all existing and proposed structures <br /> • Existing and proposed structures on the parcel including all decks°porches walkways etc:must show dimensions for ALL items <br /> J Existing and proposed sanitary system and well locations including distances to existing and proposed structures <br /> • Heights for all existing and proposed structures NOTE: Height is measured from lowest adjacent grade to the highest root'peak <br /> J (Commercial/Industrial Only) Existing and proposed parking: must show dimensions and proposed number of stalls <br /> J Existing and proposed driveways: must show dimensions and width NOTE: Driveways must have a cleared width of 20 Ii mid,a <br /> cleared height of 13 ft,and sufficient turn-around space for rescue services to utilize <br /> .1 North arrow <br /> J Vegetation proposed to be removed or disturbed <br /> • Location and extent of proposed filling/grading <br /> J Location and type of erosion control measures <br /> J Construction plans shall be submitted with this application for all Commercial/Industrial related construction. <br /> Construction plans shall show interior layout,exterior profiles and exterior heights. <br /> J Proposed building/structure locations must be staked prior to submitting this application to the Land Services Depart ntent. <br /> County staff will do an onsite visit to verify site conditions. If all proposed structures(including decks,patios, retaining <br /> wails.etc)are not staked upon County staff visit,the permit may not be approved and may be returned to the applicant. <br /> J If all existing structures on the parcel are not shown and dimensioned on the plot plan drawing,the permit may not be <br /> issued and may be returned to the applicant. <br /> Page 2 of 5 <br /> Burnett County, WI Land Use Application — Rev 04/2024 <br />