Laserfiche WebLink
w4 AR t%1PAVT <br /> Wisconsin Department of Safety and Professional Services y1r ram. Phone:608-266-21 l2 <br /> Division of Industry Services Web:hM://dsps.wi.gov <br /> 4822 Madison Yards Way t 1 Email:dsus wisconsin.gov( <br /> PO Box 7302 a <br /> Madison,WI53707 �`� � � �' Tony Evers,Governor <br /> Dan Hereth,Secretary <br /> May 11, 2023 Conditionally <br /> APPROVED <br /> CONDITIONAL APPROVAL DEPT.OF SAFETY AND PROFESSIONAL <br /> SERVICES <br /> DIVISION OF INDUSTRY SERVICES <br /> PLAN APPROVAL EXPIRES: 2025-5-11 <br /> Plan Review: PWTS-052300753-C <br /> Mary Huppert <br /> 25720 Firefly Lane SEE CORRESPONDENCE <br /> Webster,WI <br /> SITE: <br /> Olson <br /> 11840 M Y Road <br /> Burnett County <br /> Town of Trade Lake <br /> NE%SE%S4 T37 R18W <br /> FOR: <br /> Description: 3 Bedroom-450 GPD—14"to GeoMat Mound Manual—(May 2022-2027) <br /> limiting factor—Effluent Filter- Pressure Distribution Component Manual—Ver. <br /> Maintenance required 2.1 (May 2022-2027) <br /> The submittal described above has been reviewed for conformance with applicable Wisconsin Administrative Codes <br /> and Wisconsin Statutes.The submittal has been CONDITIONALLY APPROVED.This system is to be constructed and <br /> located in accordance with the enclosed approved plans and with any component manual(s) referenced above.The <br /> owner,as defined in chapter 101.01(10),Wisconsin Statutes, is responsible for compliance with all code requirements. <br /> No person may engage in or work at plumbing in the state unless licensed to do so by the Department per s.145.06, <br /> stats. <br /> The following conditions shall be met during construction or installation and prior to occupancy or use: <br /> Reminders <br /> • If using the existing septic tank,it must be inspected for watertightness and structural soundness,size and <br /> baffles,and must be brought into conformance with the requirements of ch.SPS 383,Wis.Adm.Code. <br /> • The mound site shall be properly prepared prior to plowing.Any grasses longer than 6"shall be cut short and <br /> removed.To avoid matting,any leaves or loose organic matter shall be raked up and removed. Cut trees and <br /> shrubs flush to the ground and leave stumps.Avoid operating equipment on the mound site. If necessary, use <br /> only tracked equipment,during dry conditions,with minimal passes,to avoid compaction. <br /> • 12"of sand shall be installed between the contour and the bottom of the GeoMat product. <br /> • Orifice Shields are required. <br />