Laserfiche WebLink
Safety and Buildings <br /> 10541N RANCH ROAD <br /> HAYWARD WI 54843 <br /> *isconsin TDD (808)264-8777 <br /> www.commerce.state.wi.us/sb <br /> Department of Commerce www.wisconsin.gov <br /> Jim Doyle,Governor <br /> Cory L.Nettles,Secretary <br /> October 21,2003 <br /> CUST ID No.225851 AITN•POWTS Inspector <br /> RICHARD HOPKINS ZONING OFFICE <br /> HOPKINS SAND&GRAVEL BURNETT COUNTY SPIA <br /> 27760 HWY 35 7410 CTH K#102 <br /> WEBSTER WI 54893 SIREN WI 54872 <br /> CONDITIONAL APPROVAL <br /> PLAN APPROVAL EXPIRES: 10/21/2005 Identification Numbers <br /> Transaction ID No.927866 <br /> SITE: Site ID No.666343 <br /> Blume Riverside Inc Please refer to both:identification numbers, <br /> 27043 State Rd 35 above,in all correspondence with the'agency. <br /> Town of Meenon, 54893 <br /> Burnett County <br /> FOR:Replacement holding tank,1000 GPD <br /> Object Type:POWT System Regulated Object ID No.: 924623 <br /> The submittal described above has been reviewed for conformance with applicable Wisconsin Administrative Codes <br /> and Wisconsin Statutes. The submittal has been CONDITIONALLY APPROVED. The owner,as defined in <br /> chapter 101.01(10),Wisconsin Statutes,is responsible for compliance with all code requirements. <br /> The following conditions shall be met during construction or installation and prior to occupancy or use: p <br /> General Approval Conditions: C()! <br /> • This system has been reviewed and approved as an Individual Site Design.The system shall be constructed in <br /> accordance with the approved plans and ch.Comm. 83,Wis.Adm.Code. pEPi <br /> • In the event this holding tank malfunctions so as to create a health hazard,the property owner must follow the <br /> contingency plan as described in the approved plans.In addition, the owner must insure that the operation, <br /> maintenance and monitoring duties as described the Holding Tank Component Manual are complied with.A <br /> copy of this information must be given to the owner upon completion of the project. SE <br /> Key Item(s) <br /> • The sizing for this holding tank approval is based on pumping records from 1992—2002. These are yearly <br /> pumping records and have been averaged and divided by 300 days per year that the facility is open. <br /> • Manhole cover or service port to be no more than 25'from service road or drive per Holding Tank Manual, <br /> Table 1. <br /> Notes <br /> • This approval does not include plans for the general plumbing systems or sewer piping leading to the <br /> septic/holding tank that may be required for this project. See section COMM 82.20,Wis.Adm.Code,to <br /> determine if plan submittal and approval is required. <br /> Reminders <br /> • A meter shall be installed by a properly licensed plumber on the water system that adequately measures the <br /> amount of water used by the structure,excluding hose bibs and wall hydrants,which do not discharge into the <br /> sanitary system. <br />