Laserfiche WebLink
9. The permittee shall maintain the project in good condition and in compliance with the <br /> terms and conditions of the permit, NR 328, Wis. Admin. Code and s. 30.206, Stats. <br /> 10.This project shall comply with all conditions identified in Wisconsin Administrative <br /> Code NR 328, and identified in the Instructions for the General Permit application. <br /> 11.You must submit a series of photographs to the Department, within one week of <br /> completing work on the site. The photographs must be taken from different vantage <br /> points and depict all work authorized by this permit. <br /> 12.You, your agent, and any involved contractors or consultants may be considered a <br /> party to the violation pursuant to Section 30.292, Wis. Stats., for any violations of <br /> Chapter 30, Wisconsin Statutes, or this permit. <br /> 13.Construction shall be accomplished in such a manner as to minimize erosion and <br /> siltation into surface waters. Erosion control measures (such as silt fence and straw <br /> bales) must meet or exceed the technical standards of ch. NR 151, Wis. Admin. <br /> Code. The technical standards are found at: <br /> http://dnr.wi.gov/topie/stormwater/standards/const standards.html. <br /> 14.All equipment used for the project, including but not limited to tracked vehicles, <br /> barges, boats, silt or turbidity curtain, hoses, sheet pile, and pumps shall be de- <br /> contaminated for invasive and exotic viruses and species prior to use and after use. <br /> The following steps must be taken every time you move your equipment to avoid <br /> transporting invasive and exotic viruses and species. To the extent practicable, <br /> equipment and gear used on infested waters shall not be used on other non-infested <br /> waters. <br /> 1. Inspect and remove aquatic plants, animals, and mud from your equipment. <br /> 2. Drain all water from your equipment that comes in contact with infested waters, <br /> including but not limited to tracked vehicles, barges, boats, silt or turbidity curtain, <br /> hoses, sheet pile and pumps. <br /> 3. Dispose of aquatic plants, animals in the trash. Never release or transfer aquatic <br /> plants, animals or water from one waterbody to another. <br /> 4. Wash your equipment with hot (>104° F) and/or high pressure water, <br /> - OR - <br /> Allow your equipment to dry thoroughly for 6 days. <br />