Laserfiche WebLink
Safety and Buildings <br /> 10541N RANCH ROAD <br /> HAYWARD WI 54843 <br /> ` TDD#:(608)264-8777 <br /> AIMSconsin www•commerce.statemi.ute.wi.us <br /> Department of Commerce Tommy G.Thompson,Governor <br /> Brenda J.Blanchard,Secretary <br /> October 03,2000 <br /> CUST ID No.227691 ATTIC•POWTS INSPECTOR <br /> WADE A RUFSHOLM ZONING OFFICE <br /> 24702 LIND RD BURNETT COUNTY SPIA <br /> PO BOX 514 7410 CTH K#102 <br /> SIREN WI 54872 SIREN WI 54872 <br /> RE: CONDITIONAL APPROVAL Identification Numbers <br /> PLAN APPROVAL EXPIRES: 10/03/2002 <br /> Transaction ID No.435824 <br /> Site ID No. 198930 <br /> Please refer to both identification numbers, <br /> SITE: above,in all correspondence with theagency. <br /> Site ID: 198930, MIKE HOWE <br /> BURNETT County,Town of LINCOLN;PERIDA RD,WEBSTER 54893 <br /> NEIA,SWIA,S2,T39N,R17W <br /> FOR: NEW MOUND,300 GPD <br /> Object Type:POWT System Regulated Object IDNo.: 762023 <br /> The submittal described above has been reviewed for conformance with applicable Wisconsin Administrative Codes <br /> and Wisconsin Statutes. The submittal has been CONDITIONALLY APPROVED. The owner,as defined in <br /> chapter 101.01(10),Wisconsin Statutes, is responsible for compliance with all code requirements. <br /> The following conditions shall be met during construction or installation and prior to occupancy or use: P•O'VIf <br /> Condid <br /> 1. This plan action is subject to designer comments on the plan. •,I, <br /> 2. The maintenance plan for this system must be given to the owner of the POWTS. C� `y <br /> 3. The orientation of the mound system must be such that the longest dimension is oriented along the ,P R�MErtt <br /> surface contour per COMM 83.44(6)(a)2. plv; <br /> 4. Limit activities in the area 15'beyond the down slope edge of the mound per Mound Component Manual. <br /> 5. Maintain well and waterline set backs per COMM 83.43(8)(1). G <br /> 6. Per Table 6 of the Pressure Distribution Manual,the force main maximum allowable size is 1.5" for SEE CORRi <br /> design. (The designer may also change the manifold to 1.5"if he so chooses.) <br /> 7. The proposed pump is near its limit with the proposed total dynamic head. If upon installation,the total <br /> dynamic head increases,the proposed pump must be reevaluated and may be inadequate. <br /> 8. Turn up ells with valves and valve boxes or other means of flushing the lines shall be provided. <br /> 9. Holes must be drilled with sharp bit and all burrs and foreign matter removed before installation. <br /> 10. The observation pipes shall be located at opposite ends of the distribution cell at a distance of <br /> approximately equal to 1/6 the distribution cell length. <br /> A copy of the approved plans,specifications and this letter shall be on-site during construction and open to <br /> inspection by authorized representatives of the Department,which may include local inspectors. All permits <br /> required by the state or the local municipality shall be obtained prior to commencement of <br /> construction/installation/operation. <br />