Laserfiche WebLink
PLOT PLAN REQUIREMENT <br />A plot plan drawing is required to be submitted along with this application. The plot plan drawing shall either be drawn to <br />scale, in feet, or be FULLY dimensioned in feet. Please note the scale on the drawing, if one is used. The plot plan drawing shall <br />be on letter or legal size paper with North being at the top of the page. (Make sure all relevant items below are shown — check <br />each relevant box): <br />Property lines, road right-of-ways, and road centerlines including distances to property lines, road right-of-ways and road <br />centerlines for all existing and proposed structures on the parcel <br />W Ordinary High Water Mark (OHWM) when existing, and distances to it from all existing and proposed structures <br />4$ Provide Total Impervious Surface (IS) Percentages including new existing and proposed development. This standard is only <br />applicable if the proposed project is within 300' of the OHWM of any body of water. You only need to count the <br />surfaces that are partially or entirely within 300' of the OHWM of a body <br />proposed impervious surfaces in square feet by the total square footage of 5 plc u'a�15 r <br />by 100 to get a percentage. Example: 2,500 square feet of IS within 300' 1 I / �� 0O C� <br />impervious surfaces (I acre = 43,560 square feet). Impervious surfaces ins //Q� s Z� 7 <br />decks, patios, cement/asphalt/gravel driveways, etc. If the proposed projec / <br />If the impervious surface exceeds 30%, you will need to apply for a variar , b� Z� 3 �j <br />built structures within the same footprint, no impervious surface calculat aQ <br />survey when there are disputes over this calculation. <br />Floodplain and wetland areas/boundaries and distances to them from all ex <br />f Existing and proposed structures on the parcel including all decks/porches/ <br />Existing and proposed sanitary system and well locations including distant <br />RF Heights for all existing and proposed structures NOTE: Height is measurec <br />❑ (CommerciallIndustrial Only) Existing and proposed parking; must show <br />�l Existing and proposed driveways; must show dimensions and width NOTE <br />cleared height of 13 ft, and sufficient turn -around space for rescue services t <br />North arrow <br />❑ Vegetation proposed to be removed or disturbed 1J o to t <br />❑ Location and extent of proposed filling/grading <br />❑ Location and type of erosion control measures <br />/712 <br />176 <br />. D S,`f7 q 613 <br />Construction plans shall be submitted with this application for all Commercial/industrial related construction. <br />Construction plans shall show interior layout, exterior profiles and exterior heights. <br />14 Proposed building/structure locations must be staked prior to submitting this application to the Zoning Office. County staff <br />will do an onsite visit to verify site conditions. If all proposed structures (including decks, patios, retaining walls, etc) are <br />not staked upon County staff visit, the permit may not be approved and may be returned to the applicant. <br />❑ If all existing structures on the parcel are not shown and dimensioned on the plot plan drawing, the permit may not be <br />issued and may be returned to the applicant. <br />Page 2 of 4 <br />Burnett County, WI Land Use Application — Rev 1/2018 <br />