2019/07/11 - LAND USE - LUP - Accessory Structure (Non-Bunkhouse) - LUP-19-254

Home Browse Search

I PLOT PLAN REQUIREMENT either be drawn to s plot plan drawing U required to io ed in feet Please note the salong with this cale on the drawing, on. The plot if one is used. Thlan drawing e plot plan drawing shall scale, in feet, or be FULLY dimensioned in be on letter or legal size paper with North being at the top of the page. (Make sure all relevant items below are shown — check each relevant box): ways, and road centerlines including distances to property lines, road right-of-ways and road ❑ Property lines, road right -of - centerlines for all existing and proposed structures on the parcel ❑ Ordinary High Water Mark (OHWM) when existing, and distances to it from all existing and proposed structures ❑ Provide Total Impervious Surface (IS) Percentages thin 300' oft a OHWM of any body f water.Youonly need to count the impervious applicable if the proposed pvelopment. This standard is only roject ivide the surfaces that are partially orin sql uare feet by the totaly within 300' of the Osquare of a body of water. To ca c proposed impervious surfaces footage of the parcel above the OHWM. Then tmultiply that number by 100 to get a percentage. Example: 2,500 square feet of IS within 300' of OHWM - 43,560 square foot parcel x 100 = 5.740 imited square ous surfaces include but are not I impervious surfaces t/ acre t 43,560drivewayfeet). tetc. If thelproposed project exceeds 15% impervious surface,mitigation i s required. decks, patios, cement/asphalt/grave Y ly for a variance. NOTE: if you are only replacing existing If the impervious surface exceedsfootprint, you will n e d to iousurface calculat ons are needed. Land Services reserves the ightgto y built structures within the same pr require a survey when there are disputes over this calculation. ❑ Floodplain and wetland areas/boundaries and distances to them from all existing and proposed structures ❑ Existing and proposed structures on the parcel including all decks/porches/walkways/etc; must show dimensions for ALL items ❑ Existing and proposed sanitary system and well locations including distances to existing and proposed structures ❑ Heights for all existing and proposed structures NOTE: Height is measured from lowest adjacent grade to the highest roof peak ❑ (CommerciaVIndustrial Only) Existing and proposed parking; must show dimensions and proposed number of stalls ❑ Existing and proposed driveways; must show dimensions and width NOTE: Driveways must have a cleared width of 20 ft and a cleared height of 13 ft, and sufficient turn -around space for rescue services to utilize ❑ North arrow ❑ Vegetation proposed to be removed or disturbed ❑ Location and extent of proposed filling/grading ❑ Location and type of erosion control measures ❑ Construction plans shall be submitted with this application for all Commercial/Industrial related construction. Construction plans shall show interior layout, exterior profiles and exterior heights. ❑ Proposed building/structure locations must be staked prior to submitting this application to the Land Services Department. County staff will do an onsite visit to verify site conditions. If all proposed structures (including decks, patios, retaining walls, etc) are not staked upon County staff visit, the permit may not be approved and may be returned to the applicant. ❑ If all existing structures on the parcel are not shown and dimensioned on the plot plan drawing, the permit may not be issued and may be returned to the applicant. Page 2 of 4 Burnett County, WI Land Use Application — Rev 1/2019