2019/06/19 - SANITARY - SAN - Repl HT - SAN-19-65

Home Browse Search

HOLDING TANK MANAGEMENT PLAN 77., ,l,jl, This Private Onsite Wastewater Treatment System (POWTS) has been designed, and is to be installed aind maintaine4 according to Comm. 83, Wis. Admin. Code, the Holding Tank Component Manual for Private Onsite Wastewater Treatment Systems (SBD-10S71-P;June'11, 1999), and the Burnett County Private Sewage System Ordinance. . 1. This POWTS has been designed to accommodate a maximum daily flow of -:2.00 gallons of domestic wastewater per day. 2. The owner of t is l'iPOWTS is responsible 'for system operation and maintenance, including all pr visions in the attached Holding Tank ServicingContract and Maintenance Agreements, 3. Each time the wastewater in the tank reaches 90% of the tanks) capacity or a level of 12"_ below the inlet (at which time the alarm will activate), the pumper listed in the current Servicing Contract must be called to empty the tank contents and dispose_ of them in accqr04nce.:W.ith NR 113, Wis. Admin. Code. At each pumping the pumper should visually inspect the condition of the tank, risers and manhole covers) and verify that any required locks are present. 4. The owner may not remove any of the wastes from the holding tanks, or cause such wastes to be- removed by any person not authorized to do so under Ch. 281, Wis. Statutes. The discharge of wastes from this holding tank to the ground surface, including intentional discharges and discharges caused by neglect, constitutes a failing private sewage system and may result in issuance of correction orders by the county. 5. Anyl ime a defect 's identified or malfunction occurs, it shall be reported to the person(s) identified in the I er's.Manual for this POWTS. Repair or correction of such failure or malfunction shall comply with Comm. 83, Wis. Admin. Code and the Burnett County Private Sewage System-Ordinance. 6. No one should enter a holding tank for any reason without being in full compliance with OSHA standards for entering a confined space. The atmosphere within.these tanks may F, contain letfi,60�kba e jjj,and rescbe of a person from the interior of the tank may be difficult or impossible. 7. In the event that this POWTS fails and cannot be repaired, a code compliant replacement holding tank may be installed in the same location (a new sanitary permit is required for such a replacement). 8. If this POWTS is replaced, or its use discontinued, it shall be abandoned in accordance with Comm. 83.33 Wis. Admin. Code.