2005/12/07 - SANITARY - SAN - New Mound <24" - 30819

Home Browse Search

Safety and Buildings 10541 N RANCH ROAD commerce.wi.gov HAYWARD WI 54843 TDD#:(608)264-8777 isconsin www.commerce.wi.gov/sb/ Department of Commerce www.wisconsin.gov Jim Doyle,Governor Mary P.Burke,Secretary December 02,2005 CUST ID No. 232076 ATTN:POWTS Inspector ZONING OFFICE MARTY S SWERKSTROM BURNETT COUNTY SPIA PO BOX 114 7410 CTH K#102 LUCK WI 54853 SIREN WI 54872 CONDITIONAL APPROVAL PLAN APPROVAL EXPIRES: 12/02/2007 Identification Numbers Transaction ID No. 1217P9 SITE: Site ID No. 707587 Van&Roxanne Brock Please refer to both identification numbers, f 12081 Sandy Ln above,in all correspondence with the agency, l..n Town of Trade Lake l.• Burnett County NEIA,SW1/4,S28,T37N,R18W FOR: Description:New mound,4 bedroom residence EPAI Object Type:POWTS Component Manual Regulated Object ID No.: 1051874 Maintenance required; 600 GPD Flow rate; 26 in Soil minimum depth to limiting factor from original grade; System(s):Mound Component Manual-Version 2.0, SBD-10691-P(N.01/01),Pressure Distribution Component SEE Manual-Version 2.0,SBD-10706-P(N.01/01) The submittal described above has been reviewed for conformance with applicable Wisconsin Administrative Codes and Wisconsin Statutes. The submittal has been CONDITIONALLY APPROVED. The owner,as defined in chapter 101.01(10),Wisconsin Statutes,is responsible for compliance with all code requirements. No person may engage in or work at plumbing in the state unless licensed to do so by the Department per s.145.06, stats. The following conditions shall be met during construction or installation and prior to occupancy or use: General Approval Conditions: • This system is to be constructed and located in accordance with the enclosed approved plans and with the design manuals noted above. • In the event this soil absorption system or any of its component parts malfunctions so as to create a health hazard,the property owner must follow the contingency plan as described in the approved plans. In addition, the owner must insure that the operation,maintenance and monitoring duties as described in section VIII of the mound component manual are complied with.A copy of this information must be given to the owner upon completion of the project. Key Item(s) • The designer proposes to install a state approved effluent filter to achieve the requirement of wastewater particle size. Pursuant to outlet filter product approval stipulations,maintenance information must be given to the owner of the POWTS explaining that periodic cleaning of the effluent filter is required. The access opening used to service the filter shall terminate at or above finished grade with a watertight cover. Note • The changes made to this plan by this reviewer were discussed with and approved by the system designer. • The bottom of the distribution cell shall be level per the Mound Component Manual. The"D"dimension shall be a minimum of 12". The maximum finished slope of the mound surface shall be equal to or less than 3:1 per the Mound Component Manual.