Laserfiche WebLink
pa 04 <br /> PLOT PLAN RE UIREM ENT <br /> A plot plan drawing is required to be submitted along with this application. 'lite plot plan drawing shall either be drawn to <br /> scale,in feet,or be FULLY dimensioned in feet. Please note the scale on the drawing,if one is used.The plot plan drawing shall <br /> be on letteror le size paper with North being at the top of the page. (Make sere all relevant items belong are shown—check <br /> each relevant boa): <br /> Property lines,road right-of-ways,and road centerlines including distances to property lines,road right-of-ways and mad <br /> centerlines for all existing and proposed structures on the parcel <br /> Ordinary High Water Mark(OHWM)when existing, <br /> and psed structures <br /> J Provide Total impervious Surface(iS)Percentages i el udi !new existing and proposed de andances to it fm all existing orpment.This standard is <br /> applicable if the proposed project is within 300'of the OHWM1 of any body of water. You only need to count the impervious <br /> surfaces that are partially or entirely within 300'of the OHWV1 of a body of water.To calculate,divide the total existing and <br /> proposed impervious surfaces in square feet by the total square footage of the parcel above the OHWM.Then multiply that number <br /> by 100 to get a percentage.Example:2,500 square feet of IS within 300'of OH\1 M 43,560 square foot parcels 100-- 5.74% <br /> impervious surfaces(I acre=43,560 square feet). impervious surfaces include but are not limited to:building roofs,sidewalks, <br /> decks,patios,rcmentlas halV« <br /> p gravel driveways,etc. If the proposed project exceeds 15%impervious surface,mitigation is required. <br /> lithe impervious surface exceeds 30%,you will need to apply for a variance.NOTE: If you arc only replacing existing legally <br /> built structures within the same footprint,no impervious surface calculations are needed. Land Services reserves the right to <br /> require a survey when there are disputes over this calculation. <br /> Floodplain and wetland areas/boundaries and distances to them from all existin <br /> )KExisting and proposed structures on the parcel including , �'and proposed structures <br /> walk <br /> f.. Existing and proposed sanitary system and well locations including distances to ex stints;muptg show dimensions for ALL items <br /> rHeights for all existing and proposed structures NOTE: Height is measured from lowest adjacent cent grade toosed the ctures <br /> 11( Heights <br /> highest roofeak <br /> w <br /> (Commercial/Industrial Only)Existing and proposed parking;must shodimensions and proposed number of stalls p <br /> X Existing and proposed driveways:must show dimensions and width NOTE: Driveways must have a cleared width of 20 ft and a <br /> cleared height of 13 f2,and sufficient turn-around space for rescue services to utilize <br /> XNorth arrow <br /> Vegetation proposed to be removed or disturbed <br /> Location and extent of proposed tilling;grading <br /> J Location and type of erosion control measures <br /> Construction plans shall he submitted with this application for all Commercial/Industrial related construction. <br /> Construction plans shall show interior layout,exterior profiles and exterior heights. <br /> J Proposed building/structure locations must be staked prior to submitting this application to the Land Serices Department. <br /> County staff will do an onsite visit to verify site conditions. If all proposed structures(including decks,patios,retaining <br /> walls,etc)are not staked upon County staff visit,the permit may not be approved and may be returned to the applicant, <br /> If all existing structures on the parcel are not shown and dimensioned on the plot plan drawing,the permit may not be <br /> issued and may be returned to the applicant. <br /> Burnett County, WI Land Use Application F'Rev 1/2019 <br />