2011/07/13 - SANITARY - SAN - Other

Home Browse Search

RICHARD HOPKINS Paget 6/8/2011 • Comm 83.21(2)(c)4. The application for a sanitary permit shall be accompanied with documentation that the master plumber or master plumber-restricted service who is to be responsible for the installation or modification of the POWTS,has completed approved training on the proposed POWTS technology or method. • Comm 83.52 Responsibilities. The owner of a POWTS shall be responsible for ensuring that the operation and maintenance of the POWTS occurs in accordance with this chapter and the approved management plan under s. Comm 83.54(1). • Comm 83.52(2) A POWTS that is not maintained in accordance with the approved management plan or as required under s. Comm 83.54(4)shall be considered a human health hazard. • Comm 83.52(3) The activities relating to evaluation and monitoring mechanical POWTS components after the initial installation of the POWTS in accordance with an approved management plan shall be conducted by a person who holds a registration issued by the department as a registered POWTS maintainer. • The current owner, and each subsequent owner,shall receive a copy of this letter including instructions relating to proper use and maintenance of the system. Owners shall receive a copy of the appropriate operation and maintenance manual and/or owner's manual for the POWTS described in this approval. • The owner is responsible for submitting a maintenance verification report acceptable to the county for maintenance tracking purposes. Reports shall be submitted at intervals appropriate for the component(s)utilized in the POWTS. • A component specified in this POWTS design requires servicing at an interval of 12 months or less. Pursuant to s. Comm 83.21(2)(c)5, Wis.Adm. Code, if any part of a POWTS requires servicing or maintenance at an interval of 12 months or less, a notice of the need for such servicing or maintenance must be recorded with the deed for the property. If the maintenance or service notice has not been recorded,a sanitary permit can not be issued by the sanitary permit issuing agent. • The designer proposes to install a state approved effluent filter to achieve the requirement of wastewater particle size. Pursuant to outlet filter product approval stipulations,maintenance information must be given to the owner of the POWTS explaining that periodic cleaning of the effluent filter is required. The access opening used to service the filter shall terminate at or above finished grade with a watertight cover. Reminder • The orientation of the mound system must be such that the longest dimension is oriented along the surface contour per COMM 83.44(6)(a)2. • Limit activities in the area 15' beyond the down slope edge of the mound per Mound Component Manual. • Surface water drainage shall be diverted away from the system area per Mound Component Manual. • Materials shall conform to the requirements of COMM 84. Comm 84.10.No fixture, appliance,appurtenance, material, device or product may be sold for use in a plumbing system or may be installed in a plumbing system, unless it is of a type conforming to the standards or specifications of chs. Comm 82 and 83 and this chapter and ch. 145, Stats. • Maintain well and waterline set backs per COMM 83.43(8)(i). Consult the Department of Natural Resources for well setbacks and other regulations and exceptions. A copy of the approved plans, specifications and this letter shall be on-site during construction and open to inspection by authorized representatives of the Department,which may include local inspectors. All permits required by the state or the local municipality shall be obtained prior to commencement of construction/installation/operation. In granting this approval the Division of Safety&Buildings reserves the right to require changes or additions should conditions arise making them necessary for code compliance.As per state stats 101.12(2),nothing in this review shall relieve the designer of the responsibility for designing a safe building, structure,or component.