Laserfiche WebLink
JOHN J SOLOFRA Page 2 5/8/2009 <br /> • This approval does not include plans for the general plumbing systems or sewer piping leading to the <br /> septic/holding tank that may be required for this project. See section COMM 82.20,Wis. Adm. Code,to <br /> detennine if plan submittal and approval is required. <br /> • The gravelless system components must be installed in accordance with the manufacturer's printed instructions, <br /> the plan approval, and COMM 83 system sizing criteria. If there is a conflict between the manufacturer's <br /> instructions and the plan approval,the plan approval and code requirements will take precedence. <br /> • The designer proposes to install an outlet filter to achieve the requirement of wastewater particle size. Access <br /> to the filter for cleaning must be provided per as. Comm 84.25 (7)and(8),Wis. Adm. Code product approval <br /> conditions. Maintenance information must be given to the owner of the tank explaining that periodic cleaning <br /> of the filter is required.The outlet filter shall be installed per product approval stipulations. <br /> Reminder <br /> • Materials shall conform to the requirements of COMM 84. <br /> • Surface water drainage shall be diverted away from the system area. <br /> Maintain well and waterline set backs per COMM 83.43(8)(i). <br /> A copy of the approved plans, specifications and this letter shall be on-site during construction and open to <br /> inspection by authorized representatives of the Department,which may include local inspectors. All permits <br /> required by the state or the local municipality shall be obtained prior to commencement of <br /> construction/installation/operation. <br /> In granting this approval the Division of Safety&Buildings reserves the right to require changes or additions <br /> should conditions arise making them necessary for code compliance. As per state stats 101.12(2),nothing in this <br /> review shall relieve the designer of the responsibility for designing a safe building,structure,or component. <br /> Beginning October 1",2008,small wastewater holding tanks with estimated flows less than 3,000 gpd that are <br /> based completely on approved POWTS component manuals must be submitted to the appropriate governmental unit <br /> and will no longer be accepted by the Safety and Buildings Division for review. Please refer to s.Comm 83.22, <br /> Wis. Adm.Code for further information. <br /> Inquiries concerning this correspondence may be made to me at the telephone number listed below, or at the address <br /> on this letterhead. <br /> The above left addressee shall provide a copy of this letter to the owner and any others who are responsible for the <br /> installation, operation or maintenance of the POWTS. <br /> Since Fee Required$ 325.00 <br /> Fee Received$ 325.00 <br /> Balance Due $ 0.00 <br /> atricia L an?Wer <br /> POWTS Plan Rtegrated Services WiSMART code: 7633 <br /> (715)634-7810, Fax: (715) 634-5150,M-f 7:45 atm-4:30 pm <br /> pat.shandorf@wisconsin.gov <br /> cc: Carl J Lippert, Wastewater Specialist,(715)634-3484 <br />